Nokia Face Plate Installation Instruction

inst2.jpg (9289 bytes)

Required Tool: Number (6) Torx Wrench

Remove battery and (4) torx head screws.

	Begin to pull until the phone separate into two sections toward the top (antenna area).
	The phone is held together by two latches (release latches..., you will not break).
	The power on/off button and earpiece will either stay in face plate or attached to green circuit board.
	Place on/off button along with earpiece in your new face plate.

inst4.jpg (13904 bytes)

	Install the keypad in the new face plate.
	Replacing Keypad-- Install new keypad in face plate. Remove white/silver filament from original keypad and place onto new keypad.

inst5.jpg (15280 bytes)

	You may choose to use your original Nokia Keypad or use the new keypad that comes with the new face plate.
	Install the rear section of phone (circuit board section) onto face plate from top enabling latches to attach.
	Squeeze face plate and rear housing and check to make sure the phone is properly attached.

inst6.jpg (10391 bytes)

	Install the (4) torx head screws and tighten phone.
	Hint: You could install battery to test keypad and earpiece audio operation before installing screws. You will need to squeeze phone to compensate for screws not being installed (Symptom: Phone will not power on).
	Note: You may notice a slight hairline crack near your antenna. It's a common problem with Nokia 5100/6110/ 6120/ 6120i/ 6130/ 6150/ 6160/ 6160i/ 6160m/ 6161/ 6161i/ 6162/ 6162i/ 6162m/ 6185/ 6190/ 6210/ 6250 phones.
	Job Done -- Test your Unit

Problems & Answers

Problem: No earpiece Audio. Check the earpiece position.
Resolution: Rotate earpiece inside the power on/off button or utilize on/off button received with face plate.

Problem: No keypad operation.
You did not remove white/silver filament from original keypad or install improperly.